Solar | Attachment | Primers | HelioPrime™ PVP 100
|
| HelioPrime™ PVP 100 |
High Solids PV Installation Primer |
|
|
|
HelioPrime™ PVP 100 is a high solids content, translucent polymer-based adhesive primer. It is used to prepare single-ply EPDM or TPO roofing membranes for the highest adhesion of pre-taped PV assemblies, cover tapes and lap sealant. This will result in the highest quality and most demanding installations. HelioPrime™ PVP 100 is also an excellent choice for priming metal surfaces.
|
|
| Color |
Translucent |
| Solids Content |
20% |
| Weight per Gallon |
6.50 LB |
| Dead Load Shear Test |
0.125” max. movement |
| VOC Content |
645 grams per liter |
| Appearance |
Smooth, no lumps |
| Viscosity |
Thin, free flowing |
| Application Properties |
| Application Temperature |
20◦ F to 110◦ F (-6◦ C - 43◦ C) |
| Storage Temperature |
40◦ F to 90◦ F (4◦ C – 32◦ C) |
| Shelf Life |
One year in unopened container |
| Values are typical performance properties and characteristics based on laboratory testing. This is intended as a guide for comparison purposes and does not constitute a specification or specification range. |
|
| Resistance to Aging |
High Performance |
| Excellent Tack |
Quick Adhesion |
| Universal Primer |
Can be Used With EPDMand TPO Membranes |
| Code Approvals |
FM & UL Approved |
|
-
Thoroughly stir prior to use and re-stir every 15–20 minutes during use.
- Do not dilute HelioPrime™ PVP 100 with any liquids.
- Surfaces should be dry and clean before applying HelioPrime™ PVP 100. EPDM and TPO surfaces should be cleaned with a suitable solvent such as mineral spirits or VM&P naphtha prior to priming.
- When the surfaces are dry, apply HelioPrime™ PVP 100 with a brush, rag, or 3M Scotch-Brite™ pad fully saturated with primer. The surface should appear wet during application. Apply primer to a wider area then the actual bonding area to insure complete coverage. If using a Scotch-Brite™ pad, be sure that it is free of excessive dust from EPDM membranes. Replace pads often.
- Allow primer to dry completely (usually less than 10 minutes) before applying adhesive backed PV assembly. Drying conditions will vary depending on ambient air conditions.
|
1 Gallon Can 3 Gallon Pail |
Clean-Up
Use mineral spirits or VM&P naphtha. |
For all ADCO products, and for any other materials used in conjunction with ADCO products, users must follow individual Product Data Sheet and Material Safety Data Sheets (MSDS) for health and safety precautions. Always use protective eyewear.
Caution
All statements and technical information in this document are based on tests or data that ADCO believes is reliable. However, ADCO does not warrant or guarantee the accuracy or completeness of this information. The user has sole knowledge and control of factors that can affect the performance of ADCO’s products in the user’s intended application. It is the user’s responsibility to conduct tests to determine the compatibility of ADCO’s product with the design, structure, and materials of the user’s end product and the suitability of ADCO’s product for the user’s method of application and intended use. The user assumes all risk and liability arising out of such use. |
|
|
 |
 |
